Events Playback; Start Failure Codes Through The Parking Lights - Autostart AS-2360 TW Installation Manual

Events playback

Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is
.
OFF
• Hold down the Hood Pin-switch for 4 seconds.
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push the Pin-switch 3 more times
(down-up / down-up / down-up).
The Parking Lights and L.E.D. will flash the five events stored in memory.
The first four playback codes are Start Failure Events. There is a pause after each
event code is played back. The system will play back the most recent event first, then the
second one, and so on. If there is no event at all to report, the Parking Lights will give
one long flash.

Start Failure Codes through the Parking Lights

1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
6 x = Hood
7 x = Engine Running, no Ignition detected, or Tach before Start
Note: "x" stands for one flash of the Parking Lights
P. 28
Table 14
Events playback
Installation Guide AS-2360TW