Data Analysis - Racelogic VBOX Touch V1 Quick Start Manual

Note: The first time that the unit is used, it may take up to 15 minutes to fully acquire satellites. After this, it will
usually take 1 to 2 minutes to acquire satellites.
17. The unit is now ready to display live Accel Test results.
18. By default, VBOX Touch will automatically start recording when travelling over 0.5 km/h, this can be changed
within the General Settings.
19. Tapping on the SD Card Icon when green will manually start or stop logging data, overriding the Configured
Logging Strategy.
20. The Record Icon will show when the unit is logging data to the SD card.
If you have come to a stop, but the Record Icon is still on, press the SD Card Icon to stop the logging before
removing the card.
Sometimes, due to poor satellite visibility in a garage or close to a building, the box may start recording, even if the
car is stationary. Always check the Record Icon before ejecting the card.
IMPORTANT – The SD card shouldn't be removed when the Record Icon is on as you may lose data.
Note: If for some reason the SD card is removed whilst still recording, it may need to be repaired using a PC
before it can be reused.
21. A screenshot of what is displayed on the screen can be taken at any time by pressing the Screenshot Button.
22. To reset all test results shown on the current screen, press the Reset Button.
23. When you have finished your testing, completed test results can be viewed by pressing the Results Button.
More information on Accel Mode testing can be found here.

Data Analysis

A recorded session will be saved within the SD card as a
of data analysis software
Quick_Start_Guides_%E2%80%93_VBOX_Touch_V1/Quick_Start_Guide_%E2%80%93_VBOX_Touch_V1%3A_Accel_Mode
VBOX Test Suite.
https://en.racelogic.support//Product_Info/Performance_Meters/VBOX_Touch/VBOX_Touch_V1/
.vbo file. This can be later analysed using our next generation
13