Table of Contents
Advertisement
JANUS 900 MHz Terminal Emulation for the Model 200
Reinstalling Terminal Emulation Software
Your JANUS 900 MHz RF device with terminal emulation comes from the
factory with IRL removed and terminal emulation software and a terminal
emulation keypad installed. Follow the guidelines below if you need to
reinstall the factory default drive C and D images and terminal emulation
software on your JANUS device.
A-8
Locate the IMG<version>.EXE file on your JANUS Boot Utilities
Companion disk. This self expanding executable produces the drive C,
drive D, and system software images that you will load onto your JANUS
device.
See your JANUS user's manual for detailed instructions on creating or
changing drive C or D images.
Delete IRLDESK.EXE, IRL.BAT., and IRL001.DAT from the extracted drive
D image files.
Copy the following files from the TE application disk to the drive D image
you are building.
3270 TE Files
J93270.EXE
JAN3270.MAP
DISPTBLS.MAP
TE.BAT
TE.SEC
Make the following modifications to the CONFIG.SYS and
AUTOEXEC.BAT files to load the correct Code Page and display the
international characters. The CONFIG.SYS change sets up the display
system to use Code Page 850. The AUTOEXEC.BAT change selects Code
Page 850 for the display.
Line added to CONFIG.SYS
DEVICE=D:\DISPLAY.SYS CON=(LCD,437,1)
Lines added to AUTOEXEC.BAT
D:
MODE CON CP PREP=((850)D:\LCD.CPI)
MODE CON CP SELECT=850
NLSFUNC
CHCP 850
CODE
ControllerCODE
5250 TE Files
J95250.EXE
JAN5250.MAP
DISPTBLS.MAP
TE.BAT
TE.SEC
VT/ANSI TE Files
TNVT900.EXE
DISPTBLS.MAP
TE.BAT
TE.SEC
TE.CFG
Advertisement
Table of Contents
