Table of Contents
Advertisement
Note: You can change the hot key sequence (
menu. If you remap the hot key sequence, at the Intermec JANUS 20X0 VT/ANSI
Terminal Emulation screen you can still access the TE Configuration menu by
pressing
.
Each key or two-key sequence generates a 4-byte hexadecimal code. This code
identifies the key or keys pressed. For example:
Key
Action
B
Types a lowercase B
Shift B
Types an uppercase B
Ctrl B
None
Alt B
None
To remap a JANUS key or two-key sequence
1. Choose the key or two-key sequence to remap and determine the current 4-
byte hex code of the keys and the code you will enter to remap the keys.
For help, see the table at the end of this section.
2. On the JANUS device at the DOS prompt, type:
edlin e:\te.cfg
3. At the end of the TE.CFG file, add the Remap command:
remap=< key >= string
where:
key
is the 4-byte hex code that identifies the key or keys.
string
is the new action for the key or keys. The string can be a text
string, ASCII mnemonic, or another 2-byte hex code. If the
string includes blank spaces, enclose the entire string in
quotation marks.
4. Save the TE.CFG file and exit the ASCII text editor.
For example, whenever you press
send a message and then enter a carriage return. In the TE.CFG file, type:
remap=<405E>="My battery is low<CR>"
VT/ANSI Keyboard Remapping
) that accesses the TE Configuration
4-byte hex code
0062
0042
0002
4030
on the JANUS device, you want it to
B
B-7
Advertisement
Table of Contents
