This chapter provides information about informative error messages that you may
encounter while running JANUS terminal emulation.
Understanding Error Messages
The following tables list the error messages by category in alphabetical order. If
an error message appears on your screen, locate it in the table and use the
problem and solution columns to help you correct the error. TE error handling
routines provide error detection for local editing errors.
As shown in the illustration below, recoverable errors display in the status line
portion of the JANUS screen for 5250 and 3270 terminals only. If the status line
option is not currently selected, a recoverable error causes it to appear.
Non-recoverable errors display directly on your screen. When a non-
recoverable error occurs, your TE session ends, and you exit directly to a DOS
prompt.
Local Editing Errors
Error Message
Attn Not Processed
(5250 error)
Digit Only
(5250 error)
DUP Field Required
(5250 error)
Field minus invalid
Sign on
User.................
Password.............
Program/procedure....
Menu.................
Current library......
PROTECTED FIELD
2-4TEQ.012
Problem
The host was unable to process
your Attention request.
You have entered an invalid
character in a digit only field.
You have pressed a DUP key in a
field that does not have the DUP
bit enabled.
You have pressed the Field - key
in a nonnumeric field.
AAAnugget
AAA
nuggetTroubleshooting
Solution
Press
to reset the terminal and
try again later.
Enter a valid character for this type of
field.
Enter a valid command for this type of
field.
Use the Field Exit or Field + key.
6
6-3