Intermec 200 Quick Reference Manual page 106

JANUS 900 MHz Terminal Emulation for the Model 200 Controller
To create a macro
1. Choose the key or two-key sequence that you want to use for the macro
2. Determine the current 4-byte hex code of the macro and the activation keys.
3. On the JANUS device at the DOS prompt, type:
4. At the end of the TE.CFG file, add the Remap command:
5. At the end of the macros, type:
6. Save the TE.CFG file and exit the ASCII text editor.
For example, to activate the macro, you want to press
macro is activated, you press
carriage return. If you do not activate the macro, the JANUS device sends
an 'a.' In the TE.CFG file, type:
macro=<0061>="Send this message to the host<CR>"
runmacro=<4062>
B-8
and the key or two-key sequence that will activate the macro.
For help, see the table at the end of this section.
edlin e:\te.cfg
macro=<key>=string
where:
key is the 4-byte hex code that identifies the key or keys.
string is the new action for the key or keys. The string can be a text
string, ASCII mnemonic, or another 2-byte hex code. If the
string includes blank spaces, enclose the entire string in
quotation marks.
runmacro=<key>
where key is the 4-byte hex code that identifies the key or keys that activates
the macro.
and it sends a message and then enters a
. Then, when the