Intermec 200 Quick Reference Manual page 40

JANUS 900 MHz Terminal Emulation for the Model 200 Controller
To enable or disable the TE password
1. Press
2. Use the
3. Enter information on the Set TE Password screen
3-10
< 7
(3270 or 5250) or
configuration application.
: U
@ or to highlight Set Password and press
.
then Select OK and press
Old Password This field is for password verification
purposes. Asterisks representing the password are
displayed on the screen. An error message, "Incorrect
Old Password Entry," appears if the data you enter
does not match the original password.
Note: Leave this field blank if no password is configured.
New Password Type the new password in this field.
Asterisks are displayed in the field for each keystroke
you enter in this field. To disable the security feature,
leave this field blank.
Verify Password Type the new password again to verify that it was entered
correctly. Asterisks are displayed for keystrokes in this field.
Note: To remove an existing password, enter the current password in the Old
Password field and leave the New Password and Verify Password fields blank. @
Choose OK and press
code2 code2
nugg nugg
> 
(VT/ANSI) to access the TE
@
.
to remove password protection.