Intermec 200 Quick Reference Manual page 83

Error Message
SysRq Not Processed
(5250 error)
Note: Your JANUS device running terminal emulation software may also receive session termination error
messages from the Model 200 Controller. Session termination messages consist of a message followed by a
primary and secondary return code error, which can be used in network troubleshooting. These messages are
written to the error log file on the Model 200 Controller. For more information on the error log and session
termination messages, see Appendix A, "Troubleshooting," in the Model 200 Controller System Manual.
Problem
The host computer was unable to
process your System Request.
AAAnugget AAA
nuggetTroubleshooting
Solution
Press to reset the terminal and
try again.
6
6-5