Installing the Terminal
Make sure that you have the necessary equipment to install and connect the
246X terminal to your network.
Power supply
Power cord
Input device (badge scanner, wand, laser scanner, CCD scanner)
Optional keyboard
RS-232 or RS-232/422/485 serial communications cable
Multi-drop cable (2460 only)
Ethernet (10BaseT) cable (2461 only)
The steps to install your 246X terminal depend on the options that you
purchased and the type of network or devices to which you want to
connect the terminal.
To install and configure your 246X terminal, you need to:
Mount the 246X stationary terminal.
Connect the power supply.
Connect the input devices.
Connect a keyboard.
Connect the 246X terminal to a serial device or a network.
Connect the 2460 to an existing CrossBar network.
Connect the 2461 directly to an Ethernet network.
Charge the backup battery.
Turn on the terminal.
Configure the 246X terminal for your serial, CrossBar, or Ethernet
network.
10
Mounting the Terminal
You can mount the terminal on any horizontal or vertical surface. The
sloping front panel of the 246X terminal makes reading the status lights
easy at any angle. You can rotate the screen to accommodate any viewing
angle. The terminal is designed to be used in an indoor environment. Make
sure that the location you select is relatively dust-free, stable, and dry.
Note: Make sure that you mount the terminal so that you can easily
connect the power supply to the back of the terminal.
To mount the 246X terminal
1.
Select a flat surface. Make sure that you have easy access to the
connectors, On/Off ( ) button, status lights, and screen.
2.
Use the mounting template (at the end of this guide) to mark the
placement of the mounting holes on the mounting surface.
3.
Drill two mounting holes in your mounting surface.
4.
Place the terminal over the mounting holes and install a screw (not
provided) through each mounting hole in the 246X terminal .
Mounting
screw
(2 places)
246XG.003
11