Ethernet Configuration Bar Codes - Intermec Trakker Antares 2460 Getting Started Manual

Communications Port Interface (COM2 only)
Enable RS-232 Interface
*/D/KYK2/Z0*
*$+YK2:0*
Enable RS-422 / 485 Interface
*/S/KYK2/Z1*
*$+YK2:1*

Ethernet Configuration Bar Codes

Use these bar codes to configure the host, controller, terminal IP addresses,
default router, or subnet mask. The IP address format is n.n.n.n where each
n address is a number from 0 to 255.
Note: You cannot set the first segment to 0, 127, or 223 and above.
1. Scan a bar code: Enter Accumulate / Set Host / Controller IP Address
*+/$+NC*
*+/$+NC*
Enter Accumulate / Set Terminal IP Address
*+/$+ND*
*+/$+ND*
Enter Accumulate Mode / Set Default Router
*+/$+NX*
*+/$+NX*
Enter Accumulate Mode / Set Subnet Mask
*+/$+NS*
*+/$+NS*
26
*0*
2. Scan a value:
(0 to 255)
*0*
*2*
*2*
*4*
*4*
*6*
*6*
*8*
*8*
3. Scan this bar code: . (Period)
*.*
*.*
4. Repeat Steps 2 and 3 to set the next two numbers in the IP address
field. After you scan the last address segment, go to Step 5. Do not
scan the period after the last address segment.
5. Scan this bar code
: Exit Accumulate Mode
*-/*
*-/*
6. Repeat Steps 1 through 5 to set another Ethernet configuration
parameter.
7. Scan this bar code: Enable Ethernet Network
*$+NA1*
*$+NA1*
*1*
*1*
*3*
*3*
*5*
*5*
*7*
*7*
*9*
*9*
27