Connecting The Power Supply; Connecting Input Devices - Intermec Trakker Antares 2460 Getting Started Manual

Connecting the Power Supply

You connect power to the terminal using the main power supply.
To connect the power supply
Connect the power supply to the power connector on the terminal.
Connect the power cable from the power supply to a powered
electrical outlet.
Power
connector
2. Take a loop of the power supply cable and secure it to the strain relief
using a tie-wrap (not provided).
Strain
relief
To power
supply
12
Power supply
Power cable
246XG.005
246XG.006

Connecting Input Devices

The 246X terminal supports wands, badge scanners, laser scanners, and
CCD scanners. You can use these input devices to collect data with the
terminal:
126X, 127X, and 128X wands
1354 and 1355 badge scanners
1517, 1518, 1519, and 1545 laser scanners
1550A and 1551A laser scanners
1550B laser scanner with software V1.9 or later
1551B laser scanner with software V1.1 or later
1552 decoding laser scanner with 9745 base station
1463 CCD scanner
To connect input devices
Connect the 10-pin Stewart connector from the input device to the
scanner connector on the 246X terminal.
246XG.022
When you turn on the terminal and scan a bar code, the Good Read status
light turns on for two seconds if the bar code was scanned successfully.
13