Suspend/Unsuspend Command; Suspended State Query - Globalstar ST100 User Manual

8545-0194-01 v1.0
4.2.2.29. "Suspend/Unsuspend" command
The purpose of this command is to suspend tracking due to battery low, as well as to suspend tracking when the unit is in the
"waiting to activate" state. If this command is issued with an argument for "full suspend" when the unit is not in track, and then
a "proprietary track" command is issued while in that suspended state, this condition shall be defined as "waiting to activate"
state, and the unit will begin tracking when this command is received with the "unsuspend" or "partial suspend" argument.
The Nordic processor uses this command to transition from "battery very low", "battery low" and "battery OK" states.
BYTE BITS
0 0 - 7
1 0 - 7
2 0 - 7
3-4 0 - 7
5-6 0 - 15
Response: AA 05 80 <CRC>

4.2.2.30. Suspended State query

BYTE BITS
0 0 - 7
1 0 - 7
2 0 - 7
3-4 0 - 15
BYTE BITS
0 0 - 7
1 0 - 7
2 0 - 7
3-4 0 - 7
5-6 0 - 15
ST100 User Manual v1

SUSPEND/UNSUSPEND COMMAND

PARAMETER
Leader
Length
Command Code
Mode argument
CRC
SUSPENDED STATE QUERY
PARAMETER
Leader
Length
Command Code
CRC
SUSPENDED STATE QUERY RESPONSE
PARAMETER
Leader
Length
Command Code
Mode argument
CRC
Confidential & Proprietary Information
DESCRIPTION
Always a value of 0xAA
0x06
0x80 = Suspend / Unsuspend
0x00 = Full Suspend stop tracking messages completely
0x01 = Partial suspend reduce tracking rate to low battery rate
0x02 = Unsuspend. Track at normal tracking rate
DESCRIPTION
Always a value of 0xAA
0x05
0x81 = Suspended state query
Will contain the CRC
DESCRIPTION
Always a value of 0xAA
0x06
0x81 = Suspended state query
0x00 = Full Suspend stop tracking messages completely
0x01 = Partial suspend reduce tracking rate to low battery rate
0x02 = Unsuspend. Track at normal tracking rate
51