Pin Connector; Table 3 - 14 Pin Connector (Molex 5034801400) - Globalstar ST100 User Manual

Hide thumbs Also See for ST100:
Table of Contents

Advertisement

8545-0194-01 v1.0
Notes:
1. This list is not a complete list of acceptable solar panels. These are panels that Globalstar has identified and tested as
acceptable.
2. The VAR/installer should review the pairing of solar panel / battery and determine if the solar panel is adequate for use with
the selected battery.
3. This value is based on the efficiency of the solar charger chip, which is typically 80-85%.
4. The solar panel should be chosen for outdoor use, if the end-application will be mostly outdoors.
5. For the 140mAh solar panel, under ideal conditions, it would take ~ 10 hours to recharge a fully discharged 500mAh
battery (listed in the Power Performance Characteristics tables).

2.10.4. 14 PIN CONNECTOR

The ST100 is equipped with a 14 pin connector to provide access to serial connection, ASIC programming and Bluetooth
processor programming using external breakout/debug tools.
PIN #
FUNCTION
1
2
Bluetooth processor
programming through JTAG
3
4
5
6
7
ASIC Programming
8
9
10
Serial connection
11
Bluetooth processor
12
programming through JTAG
13
Serial connection
14
ST100 User Manual v1

TABLE 3 - 14 PIN CONNECTOR (MOLEX 5034801400)

SIGNAL NAME
3V0
SWDIO
Bluetooth processor programming line
GND
SWDCLK
Bluetooth processor programming line
GND
SAT_DBG_DATA
SAT_DBG_CLK
SAT_DBG_EN
SAT_RST_N
EXT_TX_CONN
External Serial Port Transmit
EXT_RTS_CONN
External Serial Port Request to Send
MCU/BLE_#RESET
EXT_CTS_CONN
External Serial Port Clear to Send
EXT_RX_CONN
External Serial Port Receive
Confidential & Proprietary Information
DESCRIPTION
3V supply
PCB Ground
PCB Ground
ASIC programming line
ASIC programming line
ASIC programming line
ASIC reset
Bluetooth processor reset
NOTES
The 3V supply is only meant to power loads
less than 20mA.
This is the Receive signal on the Bluetooth
processor.
This is a GPIO signal connected to the
Bluetooth processor.
This is a GPIO signal connected to the
Bluetooth processor.
This is the Transmit signal on the Bluetooth
processor.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents