Gpspgdump; Gpssnap; Gpstsdump - Globalstar ST100 User Manual

8545-0194-01 v1.0
6. Unknown Mode
Temperature Mode:
1. Nominal
2. Temperature High
3. Temperature Low
4. Unknown Mode
NOTE: Unknown Mode is typical for the first 3 to 4 minutes following device activation.

4.1.1.18. "gpspgdump"

Get one of GPS data using the BLE interface in bytes.
Normal Battery Charging Mode
Command:
Arguments:
Example:
Example response:

4.1.1.19. "gpssnap"

Get the Snapshot of GPS section in the flash. Returns the non-empty pages of the GPS section.
Command:
Arguments:
Example:
Example response:
NOTE: You can utilize these start addresses with the gpspgdump command.

4.1.1.20. "gpstsdump"

Get GPS frames form the flash in certain timestamp range.
Command:
Arguments:
Example:
Example response:
ST100 User Manual v1
gpspgdump
starting address of the page: Can be acquired using the gpssnap command
gpspgdump 54000
Bytes will be transmitted over the BLE interface.
4096 bytes of GPS data will be transmitted
gpssnap
None
gpssnap
Non-Empty start addresses: 0x54000 0x55000
gpstsdump
Timestamp enable flag: Always set this to 1
Timestamp 1: Start time in UNIX 10 digit format
Timestamp 2: End time in UNIX 10 digit format
gpstsdump 1 1595869702 1595879702
GPS frames are transmitted over the BLE interface.
Only the GPS frames that are within the timestamp range will be transmitted.
Confidential & Proprietary Information 22