Removing And Installing The Battery; Maximizing Battery Life - Intermec CK3a User Manual

Removing and Installing the Battery

Maximizing Battery Life

CK3 Mobile Computer User's Manual
Use the next table to understand how long it takes to charge your
batteries in each of the CK3 charger or dock accessories.
Charging Times for CK3 Batteries
CK3 Charging Accessory
AC20 quad battery charger
AD20 single dock
AD21 Ethernet multidock
AD22 charge-only multidock
AE33 vehicle battery adapter
AV10 vehicle dock
To maximize the time allowed to replace the main battery pack, put
the CK3 in suspend mode before removing the battery pack.
To remove and install the battery
1 Press and hold
CK3 goes into suspend mode.
2 If necessary, disconnect the handstrap from the bottom of the
CK3.
3 Press the battery release tab toward the battery until the battery
releases, and then lift it away from the CK3.
4 Insert the battery into the CK3, and press down on the battery
until it clicks into place.
Batteries are chemical devices. If the batteries are left sitting on a shelf
for long periods of time outside the CK3, the batteries slowly
discharge, eventually to zero if left uncharged. The battery chemistry
resists normal degradation if you store the battery in a charger as
opposed to leaving the battery in a discharged state. See the following
table for tips to maximize the life of your battery.
AB17 Charging Time AB18 Charging Time
up to 4 hours
up to 4 hours
up to 4 hours
up to 4 hours
up to 4 hours
up to 4 hours
for about 2 seconds. When you release
Chapter 1 — Using the Computer
up to 6 hours
up to 6 to 7 hours
up to 7 hours
up to 7 hours
up to 7 hours
up to 7 hours
, the
5