CAME RBE4024 Installation Manual page 26

F 15 - Store in Rolling Code mode
By default [ ], to add Rolling Code transmitters, you
need to access the control board and run the [U1]
procedure.
By selecting [ ] you can store the transmitters that you
want to add, and use an already stored transmitter as a
key (please, see the transmitter's packaging).
F 16 -
PIN
For protection against tampering and unwanted programming.
• Got to Programming, click on PIN [F16] and then
click on [1].
• The default PIN, 1234, will appear. The first number will be flashing. To change the PIN:
[</>] to change the number;
[ESC] to move to the next digit;
[ENTER] to end and confirm the PIN (at any time).
the display will read [Sto] to confirm that the date has been stored.
1 2 3 4
U 1 - Store Users (max. 3,000)
Storing a user transmitter is always associated to a control mode (see funtions [F 2]/[F 3]/[F 4]/[F 5]).
Remove the Memory Roll card, before proceeding.
• Enter the programming, select Store Users [U1].
• Choose which relay to associate to the code [1]/[2]/[3]/[4].
1
[ ] ON
f 1 6
1 2 3 4
1 2 3 4
[ ] OFF
1
s
u 1
4