CAME RBE4024 Installation Manual page 24

Menu map
F 2 OUT1 command mode
F 3 OUT2 command mode
F 4 OUT3 command mode
F 5 OUT4 command mode
F 6 OUT1 command duration
F 7 OUT2 command duration
F 8 OUT3 command duration
F 9 OUT4 command duration
F 10 CRP address
F 11 RS485 serial-bus speed
F 12 Set clock
F 13 Store in Memory Roll
Descripton ( the default values appear with a black backdrop )
Function
OUT1 command mode. To choose the output's command mode.
[
F 2 [ ] Timer Mode 1 <−> 60 seconds.
[
[ ] Step-by-Step Mode.
F 3 OUT2 command mode. See [ F 2 ].
F 4 OUT3 command mode. See [ F 2 ].
F 5 OUT4 command mode. See [ F 2 ].
OUT1 command duration. To set the duration of the timer command, if it is set.
F 6
[ ...<−>...
F 7 OUT2 command duration. See [ F 6 ].
F 8 OUT3 command duration. See [ F 6 ].
F 9 OUT4 command duration. See [ F 6 ].
CRP address. Assigning a univocal logic address for managing the receiver via CRP.
F 10
[ ......
RS485 serial bus speed. To set the speed on the COM port.
F 11 [ ] window 1200 Baud; [
Baud; [ ] 19200 Baud; [
Setting the clock. See detail in the corresponding chapter. It only appears when the
F 12
SIPA06 card is fitted.
Store in Memory Roll. To save the settings of stored users.
F 13
[ ]; [ ] Store.
Copy from Memory Roll. To retrieve stored settings and users.
F 14
[ ]; [ ] Copy.
F 15 Rolling Code store mode. See detail in corresponding chapter.
F 16 PIN. See detail in corresponding chapter.
] Maintained Action Mode.
] Timer Mode 1 <−> 180 minutes.
] Seconds / [ ...<−>...
] window
] 2400 Baud; [ ] 4800 Baud; [
] 38400 Baud; [
F 14 Copy from Memory Roll
F 15 Rolling Code store mode
F 16 PIN
U 1 Store Users
U 2 Delete Users
U 3 Delete all users
U 4 Code Decoding
A 4 Reset
H 1 Firmware version
] Minutes
] 57600 Baud; [
] 9600 Baud; [ ] 14400
] 115200 Baud.