General Programming
General Programming
Reading Mode
Sensor Mode
After programming, the scanner will start to sense the environment without trigger.
After a scan, it will stop and keep sensing to wait another illumination changing. In
sensor mode, a trigger also can start a scan. The sensitivity level could be chosen.
In sensor mode, the scanner could set Reading a barcode time length, and set interval length as sensing
stabilization time.
Reading a barcode time length: 01-15, corresponding to 1s, 2s, ..., 15s in 1s increments; 00: infinite.
Interval length: 01-15, corresponding to 0.5s, 1s, 1.5s, ..., 7.5s in 0.5s increments.
Reading a barcode time length
【Pro CMD:99900150】
Sensitivity is used to evaluate the scanner's ability to sense the changing environment. Users can choose a
sensitivity level which suits the environment.
High Sensitivity
【Pro CMD:99900152】
Medium Sensitivity
【Pro CMD:99900153】
Sensitivity Level Programming
There are sixteen levels of 0 to F. The lower the value is, the higher the sensitivity level is.
For instance, we could set sensitivity level to 5 level.
1、
Read"Code Programming ON"
2、
Read"
User Sensitivity"
3、
Read number "5"
4、
Read"
Code Programming OFF"
nlscan.com
Sensor Mode
【Pro CMD:99900113】
Code Programming ON
Code Programming OFF
Interval Length
【Pro CMD:99900151】
Low Sensitivity
【Pro CMD:99900154】
User Sensitivity
【Pro CMD:99900161】
Tools
Page 17