Hardware Check - IEMAI MAGIC-HT-L Operating Instructions Manual

3.2 Hardware Check

Step 1
As shown in the diagram
Connect the device power to
1.
the bench power
Step 4
1. Set the unit to 10mm
2. Manually control the XYZ axis
movement through the touch
screen
3. Observe if it moves normally as
shown
Step 2
Under normal condition, all
1.
lights of the device are lit as
shown in the figure
Step 5
1. Set movement unit 10mm
2. Control E1 and E2 extrusion by
touch screen
Observe the left and right print
3.
head gear extrusion teeth to see
if they are turning clockwise and
counterclockwise
13
Print More Materials, All For Application
Step 3
1. Click Manual
2. Set the unit to 10mm
3. Click the Z-axis up and down
respectively
Step 6
1.Through pre-heat via touchscreen
2.The temperature can be set for the
hot bed, left nozzle, and right nozzle
3.The temperature on the right
represents the set temperature
4.The temperature on the left
represents the actual temperature
5.The recommended hot bed temp
for the first warm-up：50℃±2℃
6.Left and Right Nozzle temp：210℃
±2℃
7.Please be careful of high
temperatures and handle with
caution