Table of Contents
Advertisement
3.3 Hardware Check
Step 1
1.Connect the Power of Printer and
Pedestal as shown in figure
Step 4
1.
Control the E1 and E2
extrusion via the touch screen
to see if the left and right
nozzle gears rotate as shown
in the figure
Step 2
2.Under normal condition, all lights of
the device are lit as shown in figure
Step 5
1.Through pre-heat via the screen
2.The temperature can be set for the
hot bed, left nozzle, and right nozzle
3.The temperature on the right
represents the set temperature
4.The temperature on the left
represents the actual temperature
5.The recommended hot bed temp
for the first warm-up：50℃±2℃
6.Left/Right Nozzle temp： 210℃±2℃
14
Print More Materials, All For Application
Step 3
3.Manually make XYZ axis move
through screen to observe if it
moves normally as shown in figure
Advertisement
Table of Contents
