Table of Contents
Advertisement
6.2 Adjustment of Belt Looseness
The belt may loosen after a long period of time leading to a decline in print quality, so it is
recommended that it be adjusted every six months.
First step: open the top cover, as shown on the
top 16 screws and 3 screws on both sides to
remove and take off the top cover
Step 2: Check the belt tightness, finger lightly
press the belt, belt deformation of more than
2mm, almost and the lower belt contact when
the belt needs to be tensioned.
Step 3: Loosen the two screws holding down the
belt, tighten the screws after pulling the belt tight
25
Print More Materials, All For Application
Advertisement
Table of Contents
