Table of Contents
Advertisement
6.5 Equal Height Adjustment for Dual Print Heads
1.
Use a piece of gauge in a fixed position to make the
nozzle 1 (left) and the platform spacing is just
enough for it to pass
1.
If it passes easily and there is a certain amount of
margin, then relax the two top wires as shown and
press down on the nozzle.
2.
Make the height of the platform to the thickness of
the stopper and tighten the top wire
Attention: When adjusting the nozzle height, the same height at the same point on the platform is the
best state, the right head can be slightly higher than the left head 0.05mm
After adjusting the nozzle needs to be fine-tuned to the negative limit of the Z axis, has made the
nozzle and the platform distance in 0.5-0.1mm
Sep 1
Step 3
1.
Push the nozzle 2 (right) to the left just to stay in the
position of the previous test left nozzle using the
same piece of gauge through the nozzle and
platform between
1.
If it cannot pass, then loosen the screw as shown
and push up the nozzle
2.
so that the distance between it and the platform is
just the thickness of the stopper
3.
If the No. 2 nozzle cannot be moved up
4.
Then the No. 1 nozzle down to the same height as
the No. 2 nozzle
29
Print More Materials, All For Application
Step 2
Step 4
Advertisement
Table of Contents
