Table of Contents
Advertisement
Appendix B
1.Before printing on the printing platform to apply solid glue evenly twice, as shown in the figure
can be based on the size of the print model vertical and vertical coating of the corresponding area.
Attention: The temperature of the carbon fiber board when applied cannot exceed 50 ℃ ,
otherwise the high temperature will quickly melt the glue stick resulting in uneven thickness of the
applied glue.
2. Bake the carbon fiber board into the machine heating hot bed 80℃ for 3 minutes to make the
water in the glue evaporate and reach the maximum paste strength.
3. After using for a long time, when the residual glue on the platform is too much, you can take
off the carbon fiber board and rinse it with clean water and re-glue it.
Attention: It is recommended to use the side skirt attachment type for printing model with carbon
fiber board, to avoid the model printing warpage and other bad flat production.
When printing the model, it is recommended to observe the printing situation well before leaving
the printer. Observe the forming effect of the skirt to determine whether the height of the nozzle and
platform is appropriate.
How to use the platform glue stick
37
Print More Materials, All For Application
Advertisement
Table of Contents
