Common Problems And Their Solutions; Movement; Temperature - IEMAI MAGIC-HT-L Operating Instructions Manual

7. Common Problems and Their Solutions

Only a few common problems are listed, for more questions please contact the technician directly.

7.1 Movement

Problem 1: When extruding, the extrusion gear
shake.
Problem 2: One or two of the X, Y, Z and E axes
cannot be moved, and an alarm sound appears
when you click to move
Problem 3: Opposite direction of motion

7.2 Temperature

Problem one: click
temperature does not change, a few seconds
later prompted the heating power is insufficient,
check the heating head temperature rise
Attention: temperature measurement careful of
high temperature hot hands
Problem 2: Temperature display "1023"
Problem
Problem
on the heating,
Increase the print head temperature or determine
if the head is clogged or needs to be reloaded
with material.
Check if the limit switch is pressed
Open firmware and change control code 1 or -1
the Whether the print head is installed, or whether
the wire is connected
Print head is not properly installed
33
Print More Materials, All For Application
Solution
Solution