Table of Contents
Advertisement
3.2 Device Movement Check
Step 1
1.
As shown in the diagram
Connect the device power to
2.
the cradle power
Step 4
1.
Manually control the XY axis
movement through the touch
screen
2.
Observe if it moves normally as
shown
Step 2
Under normal condition, all
1.
lights of the device are lit as
shown in the figure
Step 5
1.Through
pre-heat
touchscreen.
2.The temperature can be set for the
hot bed, left nozzle, and chamber.
3.The temperature on the right
represents the set temperature.
4.The
temperature
on
represents the actual temperature.
5.The recommended bed temp for
the first warm-up：50℃±2℃.
6.Nozzle temperature：210℃±2℃.
7.Please be careful of high temps
and handle with caution.
13
Print More Materials, All For Application
Click the Z-axis up and down
1.
respectively.
Observe if it moves normally as
2.
shown
via
the
Attention:
The chamber fan needs to
be turned on before the inner
chamber warms up, it is
the
left
recommended to use 100% of the air
volume used, and the temperature
chamber only supports a maximum
of 90 ℃ stable printing.
Step 3
Advertisement
Table of Contents
