Table of Contents
Advertisement
7.3 Print
Problem 1: Prompt #1 or #2 no material, cannot
print properly
Problem 2: The print appears to be detached
from the bottom and is carried away
Problem 3: Dual head printing does not work well
together
Problem 4: Use of automatic unload filament, but
stuck between extrusion gear and extrusion
clamp
7.4 Clean Up Carbon Blockage
Problem 1: Print again after a pause in printing
cannot be extruded
Problem
Problem
Add material at the filament-warning test
After determining that the platform is able to
print that material, adjust the platform and nozzle
gap when the zero point is small
Installing the Build Platform and Leveling for
more
information)
According to the
adjustment
spacing
Remove the extrusion clamp and cut off the
deformed front end of the material
Pull out the feed tube above the print head
Remove the filaments and cut off the expanded
filaments s at the front end and reload them.
Causes: The distance of the pumping back is too
long, the material is inside the throat, and the
time between printing is heated, which causes the
34
Print More Materials, All For Application
Solution
(see Printing -
maintenance - nozzle spacing
Solution
Advertisement
Table of Contents
