Table of Contents
Advertisement
2.3.2 Tool interface
Figure 1: Main interface
Click "Tool" to go to Figure 2
Figure 4: Pre-Heat interface
This interface allows you to
1.
set the preheat temperature
of the hot bed, left nozzle
and Right nozzle
Figure 2: Tool Interface
1.
Click "Manual" to go to Figure 3
2.
Click "Preheat" to go to Figure 4
3.
Click "Filament" to go to Figure 5
4.
Click
"Level"
automatic leveling
5.
Click "Fan" to go to Figure 6
6.
Click "Stop" to stop all execution
commands
7.
Click "Support" to view the
after-sales contact information
Figure 5: Filament interface
1.
Loading material "
2.
Unload material "
3.
E1- Left Nozzle,E2-Right Nozzle
4.
"
"Stop Loading Command
10
Print More Materials, All For Application
Here can do the following
1.
Select the moving unit of
0.1-10mm
2.
Controls the XYZ axis for unit
to
perform
movement
3.
Click "
original point"
4.
Select E1 or E2 for unit
extrusion
Figure 6: Fan Interface
"
1.
This interface allows you to set
the nozzle cooling fan E1,
"
nozzle cooling fan E2 and the
fan rate of the motherboard
fan
Figure 3：Manual
" to go back to the
Advertisement
Table of Contents
