Arm Assembly - Spacerails Level 5 Instruction Booklet

1
PREPARE THE COASTER COMPONENTS
A

ARM ASSEMBLY

Arm Holder B
Step 1: Attach one Arm Holder A and one
Arm Holder B into one Arm Sheath. Insert one
Arm Clip into Arm Holder A.
Step 2: Insert Arm Lock through Arm Holder A
and Rail Clip. Carefully turn the Arm Lock
counter-clockwise to secure it in place.
B
SEE-SAW ASSEMBLY
55mm Rails (2)
See-Saw
Rail Clip
Step 1: Cut two rails, each 55mm in length. Insert them
into the See-Saw Arm and the Rail Clip as shown above.
Step 2: Repeat for second See-Saw assembly.
Page 4
(QTY: 80)
Arm Sheath
Arm Clip
Arm Holder A
(QTY: 2)
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Note: The Arm Sheath
has two different holes:
Arm Holder B goes in
the squarish hole; all
other devices go in the
round hole.
Completed
See-Saw
assembly
Step 3: Attach one Arm Holder B into one Arm Sheath.
Insert the completed See-Saw assembly into the
Arm Sheath.
Step 4: Repeat for second See-Saw assembly, installing
the Arm Holder B on the opposite side.
Arm Sheath
Arm Holder B
Completed
See-Saw
assembly