Otto Bock 4X860 Series Instructions For Use Manual page 10

INFORMATION
Charging the C-Leg batteries with the protector installed
It may be difficult for the prosthesis user to open the charging receptacle cover through the
recess in the lengthwise closure with his/her fingers. In this case, the battery charger plug may
be used to pry open the cover.
6.2 Removing the Protective Cover
1) Pull down the textile material of the foot cuff until the Protective Cover is exposed.
2) Open or remove the closures.
3) Spread open the Protective Cover and remove it from the knee joint.
4) Fasten the two closures after removing the Protective Cover.
6.3 Installing and removing the shield insert
► Slide the shield insert into the recess of the applied protective cover from the front and let it
engage (see fig. 5).
NOTICE
Loss of stability due to inadequately installed protective cover main unit
No hold of the shield insert on the protective cover.
Ensure that the protective cover has been installed properly and that all closures are
►
fastened.
► By opening the closures and removing the protector from the knee joint, the shield insert
loses its hold and can be removed.
7 Maintenance
► During the standard inspection of the prosthesis components, also inspect the product.
7.1 Cleaning and Care
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
Only clean the product with a damp cloth and mild soap (e.g. 453H10=1-N Ottobock Der­
►
maClean).
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
8 Legal information
8.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.
8.2 CE conformity
Otto Bock Healthcare Products GmbH hereby declares that the product is in compliance with
applicable European requirements for medical devices.
The full text of the regulations and requirements is available at the following Internet address:
http://www.ottobock.com/conformity
10