Otto Bock 4X860 Series Instructions For Use Manual page 8

2.2 Function
The protector provides a means of enclosing the C-Leg electronic knee joint, including the tube
adapter, to enhance its appearance and function. The housing of the knee joint is protected
against external influences by the protector, e. g. scratching and surface contamination. The pro­
tector is not required for the proper and safe functioning of the joint.
3 Intended use
3.1 Indications for use
The product is to be used solely for lower limb exoprosthetic fittings.
3.2 Conditions of use
The product was developed for everyday use and must not be used for unusual activities such as
extreme sports (free climbing, paragliding, etc.).
3.3 Contraindications
• All conditions which contradict or go beyond the specifications listed in the section on
"Safety" and "Indications for use".
4 Safety
4.1 Explanation of warning symbols
Warning regarding possible risks of accident or injury.
CAUTION
Warning regarding possible technical damage.
NOTICE
4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. Consequences are presented as follows if more than one consequence is possible:
> E.g.: Consequence 1 in case of failure to observe the hazard
> E.g.: Consequence 2 in case of failure to observe the hazard
This symbol identifies activities/actions that must be observed/carried out in order to avert
►
the hazard.
8
1. Protector main unit
2. Upper closure (one side always stays on
the main unit)
3. Lengthwise closure
4. Protector Foot Cuff
5. Shield Insert