Xantrex Freedom EX 4000 Installation Manual page 40

Inverter/charger with 48vdc-to12vdc converter
Hide thumbs Also See for Freedom EX 4000:
Table of Contents

Advertisement

Basic Installation Procedures
Connecting to the RV-C Ports
The RV-C ports of the Freedom EX 4000 accepts a
corresponding standard patch cable with an RJ-45 (see Figure
27 ) connector.
NOTE: Do not connect the Sync cable to these ports if you are
stacking two units. The inverter will stop operating and generate
an event code 66 or 69. Remove the cable connections
immediately.
Figure 26 RV-C ports
Figure 27 RJ-45 connector pinouts/wire colors
Figure 28 RJ-45 network terminator
A
Connecting to the USB Port
The USB port is reserved for firmware updates to the Freedom
EX 4000 and must not be used for powering and charging USB
devices.
38
1
+12_CAN
2
NC
3
GND
4
CAN1_RV-C_L
5
CAN1_RV-C_H
6
GND
7
+12_CAN
8
GND
1
+12_CAN
orange/white
2
NC
orange
3
GND
green/white
4
CAN1_RV-C_L
blue
5
CAN1_RV-C_H
blue/white
6
GND
green
7
+12_CAN
brown/white
8
GND
brown
Use the supplied network
terminator (A) when the
Freedom EX 4000 is installed
as an end device in the CAN
network and also when
stacking two units together
(see Figure 15 on page 29 and
Figure 13 on page 26). Apply a
similar 120-ohm terminator to
the other end device in the
CAN network, if applicable.
Connecting to the Remote Port
The Freedom EX 4000 can accommodate the Remote panel
(PN: 808-0817-03, sold separately).
To connect the remote panel to the remote port:
1. Route and wind the cable two times through the ferrite
core (supplied with the remote panel) before extending the
connector to the port. The ferrite core has to be closest to
the Freedom EX 4000's RJ12 Remote port .
2. Plug the remote panel unit's cable connector to the RJ12
Remote port on the unit. For the location, see Figure 22
on page 37.
3. Plug the other connector to the Remote panel unit.
ferrite core
2x
remote
cable
connector
NOTE: When the remote panel is connected, turn the
inverter/charger/converter's Power button to to Standby (up
position). This allows the remote panel to control the
inverter/charger/converter's power status.
Freedom EX 4000 Installation Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

820-4080-41

Table of Contents