Otto Bock Renegade RS1 Instructions For Use Manual page 7

Stiffening Bumpers
Spectra™ Sock
Foot Shell
Renegade®
Maintenance
Warnings
Instructions for Use (R-720-003, Rev. J)
RS1 Renegade®
Renegade_A4.indd 7
Heel too hard
Foot module too stiff
Foot module too soft
Foam stiffening bumpers are included to adjust the heel stiffness during loading
response. The bumpers may be temporarily attached with tape to the inferior
aspect of the Z-Shock. If the bumpers provide excessive heel stiffness, exclude or
trim as appropriate. For permanent placement, adhere bumpers using Barge or
similar contact cement.
A Spectra™ sock is provided to protect the foot shell and minimize noise.
Spectra™ socks must be replaced at intervals appropriate to the user's activity
level. Failure to inspect and replace the Spectra™ socks may prematurely wear
the foot module, and will void the warranty.
When removing or installing the foot shell, use the Foot Shell Removal Tool
(ACC-00-10300-00) to prevent damage to the foot module.
Minimum clearance: 162mm-200mm
Maximum user weight: 166 kg (365 lbs)
Available sizes: 22cm-31cm
Heel height: 10mm
The Renegade® foot module requires periodic maintenance.
• Inspect the foot module every six months. If the user is more active, more
frequent inspection may necessary. Service as necessary. Replace Spectra™
sock and/or foot shell if worn to prevent damage to the graphite components.
• The foot module may be cleaned and/or disinfected with soap and warm water.
If the foot is exposed to water, remove the foot shell to clean and disinfect its
interior.
Failure to adhere to the guidelines of the Instructions for Use will void the
warranty.
• Never use the foot module without a foot shell. Failure to comply may cause
premature wear, loss of function, and/or product failure.
• Always use the foot module with a sock and shoe. Failure to comply may cause
premature wear, loss of function, and/or product failure.
Symptoms
• Rapid knee flexion, instability
• Heel to toe progression to rapid
• Lack of energy return sensation
Solutions
• Shift socket posteriorly in relation to the foot
• Verify appropriate foot module category
Symptoms
• Flat spot in rollover motion at slow cadences
Solutions
• Consider a lower category foot module
Symptoms
• Clicking noise at initial contact
• Excessive toe deflection with high impact
activity
Solutions
• Consider a higher category foot module
English EU
| 7
08.02.2021 15:10:59