Call Channel Programming; Channel Names - Icom IC-M502 Instruction Manual

Call channel programming

The call channel is used to select channel 9, however, you
can program your most often-used channels in each channel
group for quick recall.
q While pushing [HI/LO], push [CH/WX•DW•U/I/C] one or
more times to select the desired channel group (U.S.A., In-
ternational, Canada) to be programmed.
w Push [16•9] for 1 sec. to select the call channel of the se-
lected channel group.
• "CALL" and call channel number appear.
• The order of indication precedence is "LOCAL," "SP OFF" and
"CALL."
e Push [16•9] again for 3 sec.
(until long beep changes to
2 short beeps) to enter call
channel programming con-
dition.
• Channel number starts flash-
ing.
r Rotate the channel selector
to select the desired chan-
nel.
t Push [16•9] to program the displayed channel as the call
channel.
• Push [CH/WX] to cancel.
• The channel number stops flashing.
INT
25W CALL
TAG
CALLING
INT
25W CALL
TAG DUP
INTL

Channel names

Memory channels can be tagged with alphanumeric names
of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (! " # $
+ , – . ⁄ ) and spaces can be used.
% & ' ( )
q Select the desired memory channel.
• Cancel dual watch, tri-watch or scan in advance.
w While pushing [HI/LO], push [16•9] to edit memory chan-
nel name.
• A cursor appears and blinks.
INT
25W
TAG
äLEASURE
e Select the desired character by rotating the channel selec-
tor or by pushing [Y]/[Z] on the microphone.
• Push [SCAN] or [CH/WX] for cursor movement.
r Push [16•9] to input and set the name.
• Push [HI/LO] to cancel.
• The cursor disappears.
t Repeat steps q to r to program other memory channel
names, if desired.
3
BASIC OPERATION
9