I Set Mode Programming - Icom IC-M422 Instruction Manual

I Set mode programming

Set mode is used to change the condition of the transceiver's
functions and the microphone's own functions:
Transceiver's functions—
Scan type, Scan resume timer, Weather alert, Dual/Tri-watch,
1
Beep tone* , LCD backlight*
PWR.
Microphone's own functions—
2
Beep tone* , LCD backlight*
1
* For transceiver setting
2
* For microphone setting
In this section, instructions are for the microphone's own func-
tions only. Refer to pgs. 32 to 34 for the setting of the other
functions. (Some functions cannot be selected from the
HM-157.)
D D Entering Set mode
q Turn power OFF.
w While pushing [16•
], turn power ON.
9
• After a beep emission, a Set mode item appears at the channel
comment indicator.
e After the display appears, release [16•
r Push [16•
] to select the desired item, if necessary.
9
t Push [Y Y ] or [Z Z ] to select the desired condition of the item.
y Turn power OFF, then ON again to exit Set mode.
1 1
, LCD contrast* and Radio
2 2
and LCD contrast*
].
9
COMMANDMIC II™ HM-157
• Beep tone
You can select the silent operation
by turning beep tones OFF or you
can have confirmation beeps
sound at the push of a key by turn-
ing beep tones ON.
• LCD backlight
The LCD backlight brightness can
be adjusted from OFF, 1 (dark) to
7 (bright.)
•
" " scrolls at the channel
comment indicator.
• LCD contrast
The LCD contrast can be ad-
justable in 4 levels. 1 is the lowest
contrast, and 4 is the highest con-
trast.
•
" " scrolls at the channel
comment indicator.
12
Scrolls
12
Scrolls
49