Set Mode; I Set Mode Programming; I Set Mode Items - Icom IC-M604 Instruction Manual

I Set mode programming

Set mode is used to change the conditions of the trans-
ceiver's functions: Scan type, Scan resume timer, Weather
alert, Beep tone, Internal speaker, LCD contrast, Attenuation
level, Automatic foghorn frequency, Radio power*
2
bler type* , Scrambler code*
1
* Appears only when an optional COMMANDMIC™ is connected.
2
* Appears only when an optional scrambler unit is installed.
Available functions may differ depending on dealer setting.
q While pushing and holding [!6 • 9], push [POWER] to enter

Set mode.

• Turn power OFF in advance.
w After the display appears, release [!6 • 9].
e Rotate [SELECTOR] to select the desired item, push [ENT].
r Rotate [SELECTOR] to select the desired condition of the
item, push [ENT] to set.
t Push [CLR], or rotate [SELECTOR] to select "E E x x i i t t " then
push [ENT] to exit Set mode and returns to normal condition.
• SET MODE CONSTRUCTION
Rotate
1
, Scram-
2
and Favorite channel.
--Set --Set Mode-- Mode--
˘Scan Scan Type Type
Scan Timer Scan Timer
WX Alert WX Alert
Beep Beep
Internal Internal Speaker Speaker
Contrast Contrast
RF RF Attenuator Attenuator
Foghorn Foghorn Frequency Frequency
Radio Radio Power Power
Scrambler Scrambler Type Type
Scrambler Code Scrambler Code
Favorite Favorite CH CH
Exit Exit
SET MODE

I Set mode items

D D Scan type
The transceiver has 2 scan types: normal scan and priority
scan. Normal scan searches all TAG channels in the selected
channel group. Priority scan searches all TAG channels in se-
quence while monitoring Channel 16.
--Set Mode--
Scan Type
Priority
˘Normal
D D Scan resume timer
The scan resume timer can be selected as a pause (OFF) or
timer scan (ON). When OFF is selected, the scan pauses
until the signal disappears. When ON is selected, the scan
pauses 5 sec. and resumes even if a signal has been re-
ceived on any other channel than Channel 16.
--Set Mode--
Scan Timer
ON
˘OFF
8
(Default: Normal)
7
8
(Default: OFF)
43