Installation Of Cutting Blades - RAMMER RD2019 Operator's Manual

Turning and changing cutting blades S-JAW
7. Remove cutting blades and shim plates.
8. Finish the surfaces by grinding, flush all burrs from cutting blade and cutter
base.
Note: If burrs remain on the surface the cutting blade will not have proper contact
with the cutter base. This will cause breakage of the cutting blade.

INSTALLATION OF CUTTING BLADES

1. Reverse the cutting blade so that unused edge can be used or install a new
cutting blade.
2. Set cutting blade on the base.
3. Fit cutting blade into cutter base with screws and lock washers.
4. Use a plastic hammer to seat cutting blade into its place with proper contact.
5. Close crusher jaws and measure the clearance between cutting blades.
6. Adjust the clearance (C) between cutting blades according to specifications. If
necessary add or remove shim plates.
7. Torque screws to the specified setting.
Page 60 - Maintenance COPYRIGHT © 2013 SANDVIK MINING AND CONSTRUCTION OY
RD2019 A-JAW, D-JAW, S-JAW, M-JAW
M030035