RAMMER RD2019 Operator's Manual page 43

RD2019 A-JAW, D-JAW, S-JAW, M-JAW
The greasing points of the crusher are shown below.
A. Trunnion
B. Rod pin
C. Slew gear (S.GEAR)
D. Slew bearing
CRUSHER PARTS
1. Always grease before operation and after every 8 hours of operation.
2. Adapt greasing interval and amount of grease to working conditions.
Insufficient greasing or improper grease may cause abnormal wear of parts.
SLEW GEAR
1. Always grease before operation and after every 8 hours of operation.
2. Adapt greasing interval and amount of grease to working conditions.
3. Apply grease from grease gun to grease nipples. It is important to rotate the
slewing ring during lubrication. Complete the lubrication after rotation.
Insufficient greasing or improper grease may cause abnormal wear of parts.
Note: Use only gear grease for slew gear.
COPYRIGHT © 2013 SANDVIK MINING AND CONSTRUCTION OY
Greasing
M020007
Lubrication - Page 43