Main Parts - RAMMER RD2019 Operator's Manual

RD2019 A-JAW, D-JAW, S-JAW, M-JAW
SAFETY INSTRUCTIONS FOR LIFTING
Below are some common safety instructions concerning lifting operations. In
addition to this, the local, national standards for machines and lifting-tackles must
always be strictly observed. Please note that the list below is not all inclusive, you
must always ensure the procedure you choose is safe for you and others.
■ Do not lift load over people. No one shall be under the hoisted load.
■ Do not lift people and never ride the hoisted load.
■ Keep people clear from lift area.
■ Avoid side pull of the load. Make sure you take up the slack slowly. Start and
stop carefully.
■ Lift load a few centimeters and verify it before proceeding. Make sure the load
is well balanced. Check for any loose items.
■ Never leave the suspended load unattended. Maintain load control at all times.
■ Never lift the load over the rated capacity (see product's operating weight from
specification page).
■ Inspect all lifting equipment before use. Do not use twisted or damaged lifting
equipment. Protect lifting equipment from sharp corners.
■ Obey all local safety instructions.

3.4 MAIN PARTS

The main parts of the cutter-crusher are shown below.
A. Mounting bracket
B. Jaw
COPYRIGHT © 2013 SANDVIK MINING AND CONSTRUCTION OY
Product introduction
M010064
Operation - Page 11