Inspection And Maintenance By The Dealer - RAMMER RD2019 Operator's Manual

RD2019 A-JAW, D-JAW, S-JAW, M-JAW
WEEKLY MAINTENANCE
1. Check the main body for wear.
2. Check the pins and bushings for wear.
3. Check cylinder rod, seals and connection points for wear. Tighten if necessary.
4. Observe hydraulic oil temperature, all lines and connections.
5. Check that the crusher works smoothly by operating the jaws.
6. Tighten connections, if necessary.
EVERY 150 HOURS
Grease slew bearing.

1.3 INSPECTION AND MAINTENANCE BY THE DEALER

Note: The times given refer to the carrier hours while the attachment is installed.
INITIAL 50-H INSPECTION
It is recommended to have the first inspection done by your local dealer after 50 to
100 operating hours. Contact your local dealer for more information about the initial
50-hour inspection.
EVERY 600 HOURS OR ONCE A YEAR
This service is recommended to be done by your local dealer after 600 operating
hours or once a year, whichever comes first. Neglecting the yearly service can cause
severe damage to the crusher.
Your local dealer will reseal the crusher and replace safety decals as needed.
Contact your local dealer for more information about yearly servicing.
During this maintenance you should do the following tasks.
■ Check all hydraulic connections.
■ Check that the hydraulic hoses do not rub against anything in any boom/stick
position.
COPYRIGHT © 2013 SANDVIK MINING AND CONSTRUCTION OY
Routine maintenance
Maintenance - Page 53