Table of Contents
Advertisement
RD2019 A-JAW, D-JAW, S-JAW, M-JAW
In case of special conditions of use, please consult your local dealer for instructions.
The cutter-crusher must not be used under water.
6.6 STORAGE
LONG TERM STORAGE
Observe the following points when the product is stored. In this way the vital parts
of the attachment are protected from rust and the machine is ready to be used
whenever necessary.
1. The storage area must be dry.
2. To avoid damaging the cylinder rod, operate the cylinder to the shortest position
by leaving the crusher jaws open.
3. Insert blocks under the crusher to keep it off the ground. If the machine is stored
outside, cover it to prevent rusting.
4. Apply grease to all crusher parts. Protect mounting bracket, pin holes, cutting
blades and pivot ends with an anticorrosive agent.
5. Connections must be sealed with clean plugs to prevent oil leakage and dirt
from getting into couplings.
6. Make sure the product can not fall.
COPYRIGHT © 2013 SANDVIK MINING AND CONSTRUCTION OY
Operation
Operation - Page 39
Advertisement
Table of Contents
