Removal Of Cutting Blades - RAMMER RD2019 Operator's Manual

Turning and changing cutting blades A-JAW, D-JAW

REMOVAL OF CUTTING BLADES

Warning! Prior to maintenance or inspection, operate all the control levers to
their fully extended stroke. This will release pressure within the hydraulic
piping and prevent unexpected movement of the jaw and loss of oil through the
hydraulic lines.
Warning! Support the crusher jaw to prevent it from closing unexpectedly
during maintenance.
Used cutting blades can be recycled. Contact your dealer for more information
about local regulations of recycling.
1. Position the attachment on level ground.
2. Support the crusher jaw.
3. Make sure the carrier's transmission is in neutral and the parking brake is
engaged.
4. Stop the carrier engine.
5. Clean the cutting blades and the base.
6. Open hex socket-head screws. Remove screws, nuts and lock washers.
Page 56 - Maintenance COPYRIGHT © 2013 SANDVIK MINING AND CONSTRUCTION OY
RD2019 A-JAW, D-JAW, S-JAW, M-JAW