Table of Contents
Advertisement
User Manual
2． RF900I-8 Configurations
2.1 Initial Use
2.1.1 Step 1: Powering the reader
Plug the power cable in, with the indicator light on and sound of a short beep, reader is ready.
2.1.2 Step 2: Connecting Antenna(s) to reader
Connect the antenna(s) with the antenna port:
2.1.3 Step 3: Connecting Data Line to Reader
Method NO.1: You can connect the reader to your PC via RS-232 serial port:
Method NO.2: You can also connect the reader to your PC via TCP/IP:
2.1.4 Step 4: Operating Reader via Demo
Put the UHFDemo.exe, reader.dll, customControl.dll into the same folder, and double-click
UHFDemo.exe to run the software.
Open the software and it will shows as below:
4
Advertisement
Table of Contents
