Table of Contents
Advertisement
User Manual
If the reader is connected via RS232, please select "RS232" in the connection mode, select the corresponding serial
port number, and select the corresponding baud rate. The default baud rate is 115200. As shown below:
Then click the "Connect " button, if the serial port is not occupied, the following information will be displayed in the
Operation History below:
If the reader is connected via TCP/IP , you need to perform the following steps:
1. Make sure there is an Ethernet card in the PC.
2. Make sure that the settings of the PC and the reader are in the same network segment.
The reader as a server uses the following default settings:
IP address: 192.168.0.178
5
Advertisement
Table of Contents
