Table of Contents
Advertisement
User Manual
parameter (carrier frequency when the tag is read) also change in real time. But it will generate a lot of data. The
reader adopts a dual-CPU architecture. Two different chips are responsible for reading tags and transmitting tag data.
Reading tags and transmitting tag data are parallel, without interfering with each other, and not occupying each other's
time, so users do not need to worry Data transmission will reduce the read performance of multiple tags. Therefore,
the multi-tag recognition performance in real-time mode is the best.
Inventory tags in real-time mode.
Click Tag Inventory (Real time mode) page to switch the software interface to real time mode. Manually tick the
connected antenna. Then set the number of cycles for each command. The meaning of this parameter is the number of
repeated executions of the inventory command. For example, if it is set to 1, each inventory command executes an
anti-collision algorithm. Set to 2, then each inventory command will execute the anti-collision algorithm twice, and so
on. The default setting is 1 (the bottom layer of the reader does not support setting other values).
Next, click the "Inventory" button and read the EPC number of the tag. We can see that the EPC data of the tag is
immediately uploaded and updated in real time. If you do not click the "Stop" button, the reader will keep real-time
inventory tags, as shown in the following figure:
11
Advertisement
Table of Contents
