Description / Function; Single Components - Otto Bock 434H4-7042 Instructions For Use Manual

1 Application
The 434H4=7042 Front Mount is to be used exclusively for the application
in combination with wheelchairs or seating systems.

2 Description / Function

The 434H4=7042 Front Mount is specially used for assembling S.T.S. sup-
ports or head support hardware to wheelchairs with rigid back, for example
wood plate or plastic shell, or to wheelchairs where the back upholstery
sheathes the back frame tube uprights.

Single Components

434H4=7042 (fig. 1)
Item Article No.
1 434H4
2 435A6=1
3 502S18=M6
4 501S68=10x1
5 501T28=M6x25
3 Assembly
The kit is mounted to the back of the wheelchair by means of two round
head thread-cutting screws (4). For that you need an electric drill. Pilot-
drill two bore holes in the desired position and use the two screws (4) to
mount the attachment element (1). Put the knurled end of the accessory
component into the clamping shell (2). Use a thread-locking compound
and fix the clamping shell with two socket head cap screws to the attach-
ment element (1).
4 Liability
The manufacturer's warranty applies only if the device has been used
under the conditions and for the purposes described. The manufacturer
recommends that the device be used and maintained according to the
instructions for use.
The manufacturer is not responsible for damages caused by components
and spare parts not approved by the manufacturer. Repairs must be carried
out exclusively by authorised dealers or by the manufacturer.
Description
S.T.S. Attachment element
Clamping shell
Hexagon nut
Round head thread-cutting screw
Socket head cap screw
Quantity
1
1
1
2
2
Ottobock | 5