E-Mail Service - LS ELECTRIC XGT Series User Manual

6.6 E-mail Service

E-mail service is a service to notify the remote administrator of the status by using the system when a problem
occurs in the system. If the status of the CPU has changed or an event occurred during operation, you can deliver
the status using the mail server.
6.6.1 Email setting
(1) Click the 'Email' item from the P2P window of XG5000 to activate the 'E -Mail setting screen.
If you check Use E-Mail, the following settings are possible.
Category
using E-mail
User name
User
information
Mail address
POP3 server address
SMTP server
address
Server
Account name
Information
Password
Message
confirmation intervals
Message
surveillance period
RUN -> STOP
Event
information
STOP -> RUN
ERROR
Item
Selects whether or not to use email service. This item must be
checked before the email can be used.
Set the user name displayed when the other person receives the mail.
When set to PLC, the sender name appears as PLC when receiving
mail.
The recipient e-mail address when you clicked Reply.
Refers to the sender's mail server consisting of the user name and
mail server, and the PLC can send data and the reply can Setting high
speed to be received by the PC.
Set the IP address to the server address that receives mail from other
devices. It can be set as a mail server that supports POP3.
The IP address must be set as the server address for the PLC to send
data. Can be set to a server that supports SMTP.
Set the same account name as the email address in POP3.
Set a password to access the POP3 account.
Set the time to check if a message arrived.
This is the period to check whether the PLC mode has been changed
or not.
When the PLC mode has changed from RUN to STOP, the Ethernet
automatically sends an email.
When the PLC mode has changed from STOP to RUN, the Ethernet
automatically sends an email.
When an error occurs during PLC run, the Ethernet automatically
sends an email. Sent when an error occurs in RUN, STOP, etc.
Chapter 6 P2P service
Usage
6-32