Fisher & Paykel DOUBLE DISHDRAWER DD60DI Installation Manual page 19

Toekick Depth
NO CUTOUT
CUSTOM TOEKICK PANEL
For a Toekick Depth 40mm
Toekick panel cutting template:
PROFILE A
CUSTOM TOEKICK PANEL
For a Toekick Depth 40-88mm
Toekick panel cutting template:
PROFILE B
CUSTOM TOEKICK PANEL
For a Toekick Depth 88-100mm
Depth is measured from FRONT of door
panel (assuming thickness ~18mm) to front
face of custom toekick panel
4 After marking the panel, carefully cut or
router out the desired profile. Use the
template as a cutting guide.
IMPORTANT!
Ensure all bare edges are sealed appropriately.
!5
FITTING A CUSTOM TOEKICK PANEL
Custom Toekick Panel
1
If you require a cutout in your custom
toekick panel, choose the most
appropriate cutout profile (A or B)
depending on the final depth of your
toekick panel.
40 m m Toekick panel cutting template
1
PROFILE A
40 -8 8m m
88 -1 0 0 m m
4
5 Place the Toekick mounting bracket onto your
toekick panel. Ensure they are centered and
the horizontal ribs at the top of the template
aligns with the top surface of the panel.
6 Secure template to panel using the supplied
toekick mounting screws.
Custom toekick panel
PROFILE B
Toekick mounting
5
bracket
6
Align panel
with the ribs
2 Place the Toekick panel cutting template onto
your toekick panel. Ensure they are centered
and the template rests on the top surface of
the panel.
3 Secure template to panel either by clamping
or using the supplied mounting screws.
Toekick mounting bracket
cutting template
2
3
7
9
7
Slide the toekick onto the mounting rails
either side and screw the toekick onto
the bottom of tub on either side.
IMPORTANT!
Do not overtighten screw.
18