Fisher & Paykel DOUBLE DISHDRAWER DD60DI Installation Manual page 33

External Venting Kit
(Excludes DD60SLI9 models)
IMPORTANT!
To prevent pooling of condensation
from the vent hose, a toekick height
of no less than 100mm is required.
Services hole
If the hole is through wood, make sure
its edges are smooth and rounded.
If the hole is through metal, ensure
you fit the supplied Edge Protector to
prevent damage to the power cord.
8
IMPORTANT!
To prevent pooling of condensation
from the vent hose, a toekick height
of no less than 100mm is required.
Services hole
If the hole is through wood, make sure
its edges are smooth and rounded.
If the hole is through metal, ensure
you fit the supplied Edge Protector to
prevent damage to the power cord.
min. 100mm
9
7
PREPARATION FOR EXTERNAL VENTING THROUGH SAME CABINET
Services can be located
either side of dishwasher
VENT HOSE
ø 57mm
min. 100mm
PREPARATION FOR EXTERNAL VENTING THROUGH ADJACENT CABINET
The ø 57mm services hole should be
enlarged to accomodate the extra
venting hose by cutting out some
material from the bottom corner.
VENT HOSE + DRAIN
HOSE + INLET HOSE
ø 57mm
DRAIN HOSE +
INLET HOSE +
POWER CORD
ø 57mm
ø 38mm
ø 57mm
POWER CORD
Shelf cutouts
max. 5mm
ø 57mm
220mm
100mm
Shelf cutouts
max. 5mm
ø 57mm
220mm
100mm