Fisher & Paykel DOUBLE DISHDRAWER DD60DI Installation Manual page 8

FRONT PANEL MATERIAL SPECIFICATIONS
16 - 20mm panel thickness
Adequately sealed to withstand moisture (50
Because of it being a hot and wet environment generally, the back and sides of the
panel should be completely sealed with a waterproof vapour barrier (ie polyurethane)
to prevent damage to the panel.
The back of the panel (including any integrated handle) should be completely flush
so that the seal between the panel and the rubber trim is maintained.
Installation outside these specs may result in condensation on cabinetry surfaces.
Maximum weight of each panel: 9kg
The following calculations assume the top of the upper panel is
aligned with the top of the adjacent cabinetry.
The final panel/cabinetry alignment is achieved by adjusting the feet:
WIDTH OF ALL PANELS
Measure A (the width between adjacent door/drawer fronts)
and write it in the first box below, then complete the equation.
Clearance to adjacent
cabinet front
A
- 2x
(min. 2mm)
HEIGHT OF THE UPPER PANEL
B
minimum
height Upper Panel extension
398mm
+
(0mm recommended)
Note: The 'upper panel extension' B allows for the top of the upper
panel to extend above the chassis where required, however a
min. 2mm gap to the benchtop must be maintained.
HEIGHT OF THE LOWER PANEL
Measure C (door/drawer height (or equivalent)) and write it in the
first box below, then complete the equation.
Height of
C
Upper Panel
-
(min 717mm + B )
7
5
CUSTOM DRAWER PANEL CALCULATIONS
O C @ 80% RH)
WIDTH OF PANEL
=
(596 - 615mm)
HEIGHT OF
UPPER PANEL
=
HEIGHT OF
LOWER PANEL
Ventilation Gap
- =
(min. 8mm)
(min. 311mm)
Note: The 'upper panel extension' B allows
for the top of the upper panel to extend
above the chassis where required, however
a min. 2mm gap to the benchtop must
be maintained.
A
min. 2mm
min. 2mm
UPPER PANEL
C
LOWER PANEL
TOEKICK PANEL
WIDTH OF ALL PANELS
min. 2mm
B
min. 2mm
HEIGHT OF
UPPER PANEL
Ventilation Gap (min. 8mm)
HEIGHT OF
LOWER PANEL