Fisher & Paykel DOUBLE DISHDRAWER DD60DI Installation Manual page 32

COUNTERTOP
Moisture
10 mm
protection tape
must be applied
These marks indicate formed
bracket screw locations, if
securing by drawer removal.
If there is no side partition, you
can construct timber bracing
as something to secure into.
WARNING!
Incorrect placement of the hole
will result in damage to hoses.
Max 5mm
Max distance
between hole edge
and rear inner face
Max 10mm
Max distance between
hole edge and shelf
6
Service Holes
Can be located either side of dishwasher, close to the rear face
and the shelf, as illustrated.
If the hole is through wood, make sure its edges are smooth
and rounded.
If the hole is through metal, ensure you fit the supplied Edge
Protector to prevent damage to the power cord.
CAVITY PREPARATION
Ø 57mm
max. 450mm
Water Connection
Recommended COLD
(Maximum 60°C).
3/4" BSP (GB20) to
suit flat washer.
Water Pressure
Water softener models
Max. 1 MPa (145 psi)
Min. 0.1 MPa (14.5 psi)
Models without
water softener
Max. 1 MPa (145 psi)
Min. 0.03 MPa (4.3 psi)
IMPORTANT!
The power outlet must be
located in a cabinet adjacent
to the dishwasher cavity.
220-240 VAC min. 4.8 A
8